"Run-Time Error 6"
Posted: January 24th, 2008, 1:36 am
Sup Nightma, Psu, and Fl00d3d.....
Well Night its been like 2 yrs since i last had a problem with NR and now since its been that long, i forget how to trouble shoot them...
This error "Run-time Error 6" happened after i put my Renguard MoTD # in. When i disable Renguard it loads up right. But with it enabled i get a pop-up that says "Run-time Error 6; Overflow".
My system specs are as follows (though i seem to believe that they are not the problem)
Windows Xp Home - Most up-to-date version
16GB Ram
2.62 Dual Core Proc. Clocked at 8.73Ghz
and some more doubt that these are the problem....
As I mentioned I believe its something with RG... I will tusill around with a little bit more to see where the problem may be... as i highly believe this is on my fault and not NR's but your assistance would be very helpful in this matter. Thanks Aazorís Mé Dé
Well Night its been like 2 yrs since i last had a problem with NR and now since its been that long, i forget how to trouble shoot them...
This error "Run-time Error 6" happened after i put my Renguard MoTD # in. When i disable Renguard it loads up right. But with it enabled i get a pop-up that says "Run-time Error 6; Overflow".
My system specs are as follows (though i seem to believe that they are not the problem)
Windows Xp Home - Most up-to-date version
16GB Ram
2.62 Dual Core Proc. Clocked at 8.73Ghz
and some more doubt that these are the problem....
As I mentioned I believe its something with RG... I will tusill around with a little bit more to see where the problem may be... as i highly believe this is on my fault and not NR's but your assistance would be very helpful in this matter. Thanks Aazorís Mé Dé
